Duke's Blog

Learning is a life long journey.

Subscribe

Subscribe To This Blog

Leave a comment here to subscribe to new posts on this blog, feel free to leave a comment about anything.

Your email address will be processed and not directly exposed.

You can unsubscribe at any time by toggling the switch next to the comment.

Comments:

#3, Sunday, June 28, 2020, Micro <[email protected]~.io> wrote:

博客简约大方。

#3.1, Thursday, February 25, 2021, Tommy Tamsen <[email protected]~.com> wrote:

I'm also lookning into using PrinCube at an attachment to a 3D-printer. Are the following calculation correct? Picture width 10 cm PrinCube 1200 x 600 DPI settings PrinCube CGI set_conf "period_us=1674" Printtime[seconds]: 10/2.54=3,937 Inch 3.937600=2362 pixels 23620,001674=3,95 seconds And also, what does "Global Density" in PrinCube Settings do?

#3.2, Wednesday, March 03, 2021, Duke <[email protected]~.io> wrote:

Final Density = (Setting Page Global Density) * (Preview Page Density).
If there is no Global Density, users who set the Density too high will end up with too high a Density.

#4, Sunday, January 31, 2021, Michael Raab <[email protected]~.eu> wrote:

Nosey Dog


Please visit the original link: /subscribe